Problem |
Solution |
Too many teeth are in the cut causing the gullets to overfill | Use a coarser tooth pitch |
Too few teeth in the cut | Use a finer tooth pitch |
Over penetration of teeth, causing gullets to overfill | Increase blade speed or decrease feed rate |
Chips are being carried back into the cut | Adjust or replace the chip brush |
Parts aren’t held securely | Use a bundle clamp or tack weld stock ends |
Bad blade weld | Replace and have blade re-welded |
Erratic hydraulic system | 1. Check for air in the system 2. Check for low oil |
Belts slip under a load | Check belt tension. Replace belts if necessary. |